Dangerous But Yet Helpful Home Brew Steam Generator

Raising the temperature of mash can be a slow,To build your own home brew steam generator
yet necessary process and using a home brewyou will need an electric hot plate capable of
steam generator can cut the time. However,about 2100 watt, along with a pressure cooker,
using steam to heat the mash can also becopper tubing, the pressure weight for the cooker
dangerous as steam can cause sever burns,and a shut-off valve. The copper tubing is
quickly. While water heated to boiling atattached to the lid of the pressure cooker by
212-degrees Fahrenheit is hot, steam heated todrilling and threading the hole and using a copper
the same temperature will do more damageconnector available at most hardware stores.
simply because boiling water begins to cool asThe other end of the first copper tube is
soon as it touches your skin. Steam, on the otherconnected to the input of the shut-off valve.
hand, will need to condense to water beforeAnother tube, connected to the output of the
beginning to cool off, giving it more time to inflictvalve goes into the top of the container of mash
more damage and pain.and extends to the bottom with at least 13-inches
With that in mind, a home brew steam generatorlying near the floor of the container.
can decrease the time it takes to heat the mashThe end of this tube is pinched closed and a
by considering the same principal. Essentially,series of small holes, about one-sixteenth of an
steam can be generated in a pressure cooker andinch are drilled a half-inch apart to complete the
then piped into the container holding the mash. Ashome brew steam generator. Fill the pressure
the steam enters, it maintains its temperaturecooker about three-fourths full of clean water and
longer than boiling water will and increases theturn on the heat source, leaving the pressure
temperature of the mash at a rate of about oneweight off for now. When steam begins to rise
degree centigrade, 33.8 degrees Fahrenheit, perfrom the top tube, clearing any air from the
minute.cooker, place the weight in position and the steam
There are some precautions to be used forwill be forced through the tube, in the bottom of
making your own home brew steam generatorthe mash, beginning the heating process.
and having the right heat source is needed, orStir the mash occasionally during heating to keep
else the heat of the steam may lack enoughthe temperature uniform. To stop the heating
power to produce the sustained release of steamprocess, turn off the heat source and remove
that is needed to achieve consistent heatthe pressure weight. You can also at this time
exchange.close the shut-off valve.
Ease Of Construction For Steam Generator